Shop Hours:

Mon - Fri:
7:30am - 5:00pm
Sat-Sun: Closed

Location:

3013 North Rancho Drive, Suite 108
Las Vegas, NV 89130

Shop Hours:

Mon - Fri:
7:30am - 5:00pm
Sat-Sun: Closed

Location:

3013 North Rancho Drive, Suite 108
Las Vegas, NV 89130

Shop Hours:

Mon - Fri:
7:30am - 5:00pm
Sat-Sun: Closed

Location:

3013 North Rancho Drive, Suite 108
Las Vegas, NV 89130

Las Vegas Auto Repair Services

At ACR Motor Works, we only service BMW, MINI, ROLLS ROYCE, Audi, VW, and Mercedes-Benz automobiles. We are factory trained and have been specializing in this line for over 25 years.  We utilize the latest equipment and factory software to provide accurate diagnostics, maintenance, and repairs.

If you are in need of service for your BMW, MINI, Audi, VW, Mercedes or ROLLS ROYCE, from general maintenance to major repairs, or anything in between, call the experts today – 702-901-4075.

Common Repairs and Services:

Schedule An Appointment Today With Our Expert Technicians!

Pre-Purchase Vehicle Inspections

Always have your pre owned BMW Inspected by a private Specialist like ACR MOTOR WORKS, because most dealerships and small independent lots have a set budget for reconditioning vehicles so they will only do the necessities in order to sell the vehicle and allow other items to be your responsibility. Private sales are the worst, so you should have the vehicle inspected so you do not inherit someone else’s headache.

Please call for pricing and appointment.

ACR Diagnostic Systems

We carry three types of BMW Diagnostic software starting with:

  • GT1 System which is required for your older BMW’s and Mini’s from 1992-2005.
  • ISTA/ D and ISTA /P which is needed for your BMW, Mini, and Rolls Royce from 2002-2012.
  • ISTA+/NEXT for 2012 to present.

ACR Maintenance

Most BMW’s today will tell you what they need. From 2006 to current models they all have what is called CBS Data (Condition Based Service) where your BMW, Mini, and Rolls Royce will tell you what maintenance is due.

Older BMW’s have three indicated service recommendations indicated by either four green bars followed up with a yellow and then red or they will have a mileage countdown prior to starting your vehicle which will appear in your odometer. The first is an oil service which usually consists of an oil change and cabin filter replacement if needed. The next will be an inspection 1 which is an oil service followed up with engine air filter, Tire rotation (If Applicable), and a complete vehicle scan and vehicle inspection with test drive. The last is an inspection 2 which is all filters, spark plugs, drive belts, complete vehicle scan, and test drive. Pricing varies per series or model options.

Coding and Programming

At ACR Motor Works we also provide vehicle coding and programming. When ever you need to replace any control module or some basic component that requires learning or adaptation reset, or coding to your vehicle we have the software capabilities to perform it correctly. We carry the BMW Factory software however we do not do any performance tuning or coding.

N20 & N26

N20 and N26 Engines have an issue with their timing chains stretching and breaking timing chain guides causing these engines to jump engine timing and causing oil pump drive issues which will cause oil
pressure loss and possible bearing failure with the camshafts in the cylinder heads. BMW has currently a
mileage extension warranty of these engines of 7 years or 70,000 miles which ever comes first. However once out of warranty extension the customers are responsible for all repairs after that time or mileage has passed. We here at ACR MOTOR WORKS have the Special tools for replacing the timing chains provided there isn’t any camshaft damage or valve piston interference causing the motor needing replacement. Please call us to arrange for an inspection and estimate if your vehicle has passed the 7/70k warranty extension.